Help with failure code readnig

[Lucky78]

Hey mates

Have some issues with my bike. At fridday was everything perfect on a short ride but next morning didn't wanted to start. I managed somehow to start the engine but MIL light went on. I jumped that red connector under the seat but i dont know which failure code is that.

First are 2 short blinks then 7 long blinks and again 7 short (if i'm reading right) and here my knowledge stops

Can someone please help me with reading this failure code and what is the failure and what to do next

https://myalbum.com/album/KJVxtgA7YA6829/


Tnx for all the help

[Hound]

I'm sure someone will correct me if I'm wrong - but as far as I can interpret from the service manual, you have two fault codes: 2, and 77.

2 is MAP sensor performance problem;
         1) Loose or poor connection of the MAP sensor hose
         2) Faulty MAP sensor

77 is TBW return spring failure.

You may find it useful to read this:
https://vfrworld.com/threads/hard-to-start-after-laying-up.56987/

[Lucky78]

A lot of infos that i need  ...i'll try tomorrow things from the article because it quite sounds like my bike.

Tnx again mate...cheers

[Hound]

As I said, I've no actual experience with MIL problems so I hope I'm not giving you misinformation! But with a bit of luck it's going to be a case of cleaning some contacts as that article suggests. Good luck!

[Lucky78]

No worries, i'll let you know how it went