Help....

[vmfpg]

Hi everyone

A few months ago a car hitted the left side of my CT and broke the gear lever and the footpeg, which was replaced at the time. A couple of weeks ago and looking at the bike from the top, I noticed that the left footpeg is a bit misalign. I believe that the car bended the footpeg support a few millimeters but it wasn't noticed at the time. I recently went to the dealer to try to check it but, they didn't have any CT to compare, they told me that, even if it's bended a little bit (which they couldn't find out), it wouldn't matter that much. Nice...

Well, my issue is that, as I cannot find another CT in my area to compare, I added a picture where you can see the (small) difference in space between the support and the main frame in the front and the back of it. So, if anyone could take a picture of this support where this space can be seen, I would really appreciate it.

Thanks a lot for your help.

[Yasko]

I would take the first photo again with some thing black on the ground beneath the foot pegs which should highlight any discrepancy better.

[vmfpg]

Hi Yasko

I'm not near the bike right now, but I added a straight line on the picture. Although it might not be quite accurate, you can have a better idea of the discrepancy.

Thanks.

[Yasko]

Looks bent backwards and slightly downwards at the rear from that photo.

[Dave56]

  it definitely looks slightly bent to me as well. 

[vmfpg]

Yes it is. That's what triggered my issue and I believe that's because the footpeg support is bended (second photo). That's why I would need someone's help, to send me a pictures like my second one to check if that support is bended or not.

Thanks a lot.

[oskar]

Look at these photos if they can help you.

[superduper]

may just want the lug on the footpeg filing to adjust the angle,

I personally think that something would have snapped on the hanger rather than bend it?

just check where the peg meets the hanger, a couple of mill off the end can adjust it a lot